Steel Products Prices North America
AIIS Reports May Exports Up 25.2 Percent Year over Year
Written by Brett Linton
July 27, 2017
The following is a press release on steel exports from the American Institute for International Steel (AIIS) on July 27 2017:
Falls Church, VA. July 27, 2017. Steel exports swelled 17.3 percent from April to May – and were up 25.2 percent from a year earlier – to surpass 1 million net tons.
More than half of the 1,006,088 net tons of exports in May – 572,068 net tons – were sent to Canada. This total was 31.7 percent more than in April and 38 percent more than in May 2016. Monthly exports to Mexico, though, dipped 3.7 percent from the previous month, to 321,435 net tons, which was 5.5 percent higher than a year earlier. The European Union took in 40,907 net tons of steel from the United States in May, which was 57.8 percent more than in April and 62.2 percent more than in the previous May.
From January to May, total steel exports increased 13.3 percent to 4.46 million net tons. This included 2.26 million net tons of exports to Canada (12.2 percent higher than the total during the same time last year), 1.7 million net tons to Mexico (14 percent higher), and 157,368 net tons to the European Union (56.1 percent higher).
With both imports and exports rising by double digits through the first five months of the year, it is clear that this is not a zero-sum game, that domestic manufacturers can do very well even as the nation relies partly on imports for its steel needs. In addition, the capability utilization rate of domestic mills has risen by more than 2 percentage points this year to 74.5 percent, according to the American Iron and Steel Institute, further illustrating the health of American steel companies. As the Department of Commerce continues its Section 232 investigation of the potential impact of steel imports on national security, it would do well to take note of how much stronger U.S. firms have become even as imports have increased to meet the demands of a growing economy.
Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America
Nucor holds HR price steady this week
Nucor is holding its hot-rolled (HR) coil consumer spot price (CSP) flat this week.
SMU price ranges: Sheet, plate largely unchanged
Sheet prices varied this week. While hot-rolled (HR) coil pricing was largely flat, cold-rolled (CR) coil and tandem product pricing eased slightly reflecting the momentum shift seen last week for HR coil. SMU’s average HR coil price was flat from last week at $835 per short ton (st) – potentially emphasizing the tension between competing […]
Nucor posts $830/ton spot HR price for week of April 8
Nucor said its spot hot-rolled (HR) coil price this week will be $830 per short ton (st).
US HR prices rebound, no longer near parity with imports
US hot-rolled coil and offshore hot band moved further away from parity this week as stateside prices have begun to move higher in response to mill increases.
Galvanized buyers report solid demand, balanced inventories
Galvanized buyers reported solid demand and balanced inventories this week and were anticipating the sheet price increase announced by Cleveland-Cliffs on Wednesday.