Steel Products Prices North America
Regional Imports Through December: Other Metallic Coated Sheet
Written by Peter Wright
March 13, 2020
In 2019, most of the imports of other metallic coated sheet (mainly Galvalume) came into the Gulf, but that volume has declined as the Great Lakes volume has increased.
SMU presents a comprehensive series of import reports ranging from the first look at licensed data to the detailed look at volume by district of entry and source nation. The report you are reading now is designed to plug the gap between these two. National level import reports do a good job of measuring the overall market pressure caused by the imports of individual products. The downside is that there are huge regional differences. This series of reports breaks total YTD import tonnage of six flat rolled products into seven regions and the growth/contraction for each product and region. Then it graphs the regional history of each product since 2013. We will report regional import data for each of six flat rolled products every other month. This month, we are reporting through December.
These six reports are intended to be reference documents with very few specific comments. The charts tell the whole story. Our intent is to provide buyers and sellers with an understanding of what is going on in their region of operation. Figure 1 shows the YTD tonnage of other metallic coated sheet into each region and the huge variation between them. Figure 2 presents the same data as a pie chart. By far the highest volume region in 2019, YTD December, was the Gulf, which accounted for 45.2 percent of the total. The whole Pacific coast received minimal tonnage.
Total other metallic coated imports, YTD December, were down by 21.9 percent and decreased in all regions except the Great Lakes and North Atlantic, which were up by 79.1 percent and 36.8 percent, respectively. The Gulf region was down by 34.9 percent.
Figure 3 shows the YTD change for each of seven regions and the change at the national level
Figures 4, 5, 6 and 7 show the history of other metallic coated coil imports by region since March 2013 on a three-month moving average basis. Note, the Y axis scales are not the same.
Regions are compiled from the following districts (we will report on tonnage by district and source nation next month):
Atlantic North: Baltimore, Boston, New York, Ogdensburg, Philadelphia, Portland, St. Albans and Washington, DC.
Atlantic South: Charleston, Charlotte, Miami, Norfolk and Savannah.
Great Lakes: Buffalo, Chicago, Cleveland, Detroit, Duluth, Great Falls, Milwaukee, Minneapolis and Pembina.
Gulf: Houston, New Orleans, Mobile, San Juan, St. Louis and Tampa.
Pacific North: Anchorage, Columbia Snake, San Francisco and Seattle.
Pacific South: Los Angeles and San Diego.
Rio Grande Valley: Laredo and El Paso.
Peter Wright
Read more from Peter WrightLatest in Steel Products Prices North America
SMU Community Chat: Timna Tanners on ‘Trumplications’ for steel in 2025
Wolfe Research's Managing Director Timna Tanners discusses the 'Trumplications' for steel in the coming year in this week's SMU Community Chat.
Nucor raises hot rolled spot price to $750/ton
Nucor raised its weekly consumer spot price (CSP) for HRC this week to $750/short ton.
SMU price ranges: Most sheet and plate products drift lower
Steel sheet prices mostly edged lower for a second week, while plate prices slipped for the third consecutive week.
Nucor drops HRC price to $720/ton
After holding its weekly spot price for hot-rolled (HR) coil steady for three weeks at $730 per short ton (st), Nucor lowered the price this week by $10/st.
SMU price ranges: Sheet slips, plate falls to 45-month low
Steel sheet and plate prices moved lower this week as efforts among some mills to hold the line on tags ran up against continued concerns about demand.