Steel Products Prices North America
Regional Imports, Hot Dipped Galvanized, Through June
Written by Peter Wright
August 12, 2019
Year to date, June, total hot dipped galvanized imports were down by 44.9 percent. All regions except the Rio Grande were down. The Rio Grande was up by 46 percent.
SMU now offers a comprehensive series of import reports ranging from the first look at licensed data to the very detailed look at volume by district of entry and source nation. The report you are reading now is designed to plug the gap between these two. Our intention is to report regional imports for six flat rolled products every other month. This month we are reporting through June.
National level import reports do a good job of measuring the overall market pressure caused by the imports of individual products. The downside is that there are huge regional differences, and we believe that buyers and sellers should have an understanding of regional differences. Figure 1 shows the year-to-date tonnage into each region and the huge variation between them. Figure 1a presents the same data as a pie chart.
Figure 2 shows the year-to-date change for each of seven regions and the change at the national level.
Figures 3, 4, 5 and 6 show the history of HDG coil imports by region since March 2013 on a three-month moving average basis. Note, the Y axis scales are not the same.
Regions are compiled from the following districts (we will report on tonnage by district and source nation next month):
Atlantic North—Baltimore, Boston, New York, Ogdensburg, Philadelphia, Portland ME, St. Albans and Washington, D.C.
Atlantic South—Charleston, Charlotte, Miami, Norfolk and Savannah.
Great Lakes—Buffalo, Chicago, Cleveland, Detroit, Duluth, Great Falls, Milwaukee, Minneapolis and Pembina.
Gulf—Houston, New Orleans, Mobile, San Juan, St. Louis and Tampa.
Pacific North—Anchorage, Columbia Snake, San Francisco and Seattle.
Pacific South—Los Angeles and San Diego.
Rio Grande Valley—Laredo and El Paso.
Peter Wright
Read more from Peter WrightLatest in Steel Products Prices North America
September Import Share of US Sheet and Plate Markets
Imported sheet and plate products arrived at US ports at a slower clip in September, accounting for a lower share of the domestic market for the third straight month. That’s according to a Steel Market Update analysis of import data from the US Commerce Department and domestic shipment figures from the American Iron and Steel […]
US Apparent Steel Supply Falls Further in September
US apparent steel supply eased further in September, down 8% from August to 8.29 million net tons, according to data from the US Department of Commerce and the American Iron and Steel Institute (AISI). As the lowest monthly figure since February 2021, this was a 19-month low. September supply was 10% below the average monthly rate […]
Northwest Pipe Reports Sharply Higher Q3 Results
Engineered pipe and tube producer Northwest Pipe Co. posted sharply higher profits for the third quarter ended Sept. 30. The Vancouver, Wash.-based company said the boost was driven by strong demand and increasing backlogs from its engineered pipeline systems and precast products, according to earnings data released on Tuesday, Nov. 8 All told, Northwest Pipe posted net […]
SMU Price Ranges: Flat-Rolled Steel Falls (Yet Again)
Sheet prices fell across the board again this week as the slow grind lower that we’ve seen since last spring continued to gain speed. Hot-rolled coil prices fell $30 per ton ($1.50 per cwt) week-over-week. Declines in coated products were more pronounced, with cold rolled down $55 per ton, galvanized down $35 per ton, and […]
US Steel Exports Slip 10% in September
US steel export volumes shrunk 10% from August to September, according to the latest US Commerce Department data. 723,000 net tons of steel products exited the country during the month, now the fourth-lowest monthly export rate over the past year and a half. Recall that exports levels in August were at the third-highest monthly rate […]