Steel Products Prices North America
Weekly Mill Capacity Utilization Up to 80.1 Percent
Written by Tim Triplett
December 28, 2019
Mill capability utilization inched back over the 80 percent mark in the week ending Dec. 21. Production totaled 1,866,000 net tons at 80.1 percent capacity, up 1.2 percent from the previous week and up 0.3 percent compared with the same week last year, reported the American Iron and Steel Institute.
Adjusted year-to-date production through Dec. 21 totaled 94,450,000 net tons at an average mill utilization of 80.1 percent–up 1.8 percent from 2018 when the year-to-date utilization rate was 78.2 percent.
Following is production by district for the Dec. 21 week: North East: 207,000 net tons; Great Lakes, 681,000 net tons; Midwest, 194,000 net tons; South, 695,000 net tons; and West, 89,000 net tons, for a total of 1,866,000 tons. Production for the week saw little change in any region except the South, where output increased by 3.8 percent.
The raw steel production tonnage provided in this report is estimated. The figures are compiled from weekly production tonnage from 50 percent of the domestic producers combined with monthly production data for the remainder. Therefore, this report should be used primarily to assess production trends. The AISI monthly production report provides a more detailed summary of steel production based on data supplied by companies representing 75 percent of U.S. production capacity.
Note, capability for fourth-quarter 2019 is approximately 30.4 million tons, compared to 30.8 million tons for the same period last year and 30.6 million tons for third-quarter 2019. Year-to-date totals are adjusted for consistency with monthly data.
Tim Triplett
Read more from Tim TriplettLatest in Steel Products Prices North America
SMU Price Ranges: Sheet floor holds as market debates upside
Our average HR coil price increased $5/short ton from last week, marking a second consecutive week of modest gains. Market participants generally attributed the increase to...
Thin demand keeps plate prices hovering at lowest levels since February
Participants in the domestic plate market say spot prices appear to have hit the floor, and they continue to linger there. They say demand for steel remains thin, with plate products no exception.
SMU Price Ranges: HR crawls back to $800/ton
SMU’s HR price stands at $800/st on average, up $5/st from last week. The modest gain came as the low end of our range firmed, and despite the high end of our range declining slightly.
SMU successfully completes IOSCO review
SMU has successfully completed an external review of all our prices. The review has concluded that they algin with principles set by the International Organization of Securities Commissions (IOSCO).
Domestic plate prices could heat up despite so-so demand, market sources say
Some sources also speculated that plate could see further price increases thanks to modest but steady demand, lower imports, mill maintenance outages, and end markets less immediately affected by tariff-related disruptions.